NovaTec S3 Installation Manual - page 6
Subject to change
Page 6 of 26
Version 2.2 / Date: Sept 2013
NovaTec Kommunikationstechnik GmbH
E-Mail:
info@novatec.de
Phone: +49 (0)5251 1589-610
Technologiepark 9 / DE-33100 Paderborn
Internet:
www.novatec.de
Telefax: +49 (0)5251 1589-611
4.3 Use of this Manual
This manual is devided into single chapters. The succession and the contents of the different chapters
coincide with the succession of the tasks necessary for the installation and initializing of the S3. We there-
fore suggest reading the manual in its successive chapters as they are written, executing the tasks suc-
cessfully before moving on to another chapter. You will install and initialize the S3 successfully if you follow
the instructions in this manual as they are written.
4.4 Use of the Pictograms
Advice:
Important, please adhere to this information.
Warning:
Important information, it is essential that you adhere to this information as otherwise
malfunctions resp. damages may occur.
5
The NovaTec S3
The S3 can be used everywhere where it is necessary to convert interfaces. The S3 functions as a
gateway between IP, ISDN U
P
0-, ISDN BRI and analogue interfaces. Therefore e.g. the S3 can be op-
erated behind a telecommunication system with U
P
0 interfaces to convert the signal in analogue a/b
interfaces. Furthermore the S3 can be operated in a VoIP network to convert the signal into U
P
0-, BRI-
or analogue a/b-interfaces or to make these connections available for terminal equipment. The func-
tionality of the S3 depends on the version you purchased (see Table 1) and its configuration.
Picture 1 gives an overview of all interfaces.