Objet Alaris Preparation And Installation Manual - 5 Facility Requirements
Alaris Site Preparation Guide
Objet Confidential and Proprietary Information
DOC-04002
13
Rev. C
5 Facility Requirements
5.1 Electrical Power Requirements
5.1.1 Power Requirements
Alaris printers have the following power rating:
A Type C circuit breaker with the following specification is recommended
on the printer’s power line, subject to the local electrical code.
The Alaris 3‐D printing system requires a stable and uninterrupted
power supply. The power to the system should be supplied directly from
the main electrical panel, without any tapped feeds on the line.
5.1.2 Grounding
The Alaris printer is grounded through the single‐phase AC plug. Make
sure that the ground connection in the wall outlet is properly grounded, in
accordance with the local electrical safety codes.
5.1.3 Main Power Connectors
The Alaris system is shipped without a power cable. The power cable is
supplied by the local Objet dealer.
Voltage
Current
100–120 VAC single-phase, 50–60 Hz
7 A
200–240 VAC single-phase, 50–60 Hz
3.5 A
Table 3: Printer power rating
Voltage
Circuit Breaker
100–120 VAC
10 A
200–240 VAC
6 A
Table 4: Circuit breaker requirements