Oce im3511 Operation Manual - (Program)
SPECIAL FUNCTIONS
33
PROGRAMMING FREQUENTLY USED OPERATIONS
(PROGRAM)
This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. When you want to send a document to that destination, you can simply call up the program and the steps
will be performed automatically. This function is convenient when you frequently send documents, such as a daily
report, to the same destination. Up to eight programs can be stored.
Programs can be stored using the custom settings, and a name up to 18 characters long can be assigned.
For information on storing, editing, and deleting programs, refer to
pages 47 and 48
.
The following settings can be stored in a program:
Destination address
Resolution and exposure
Erase
Dual Page Scan
2in1
Card shot
Only one-touch and group keys can be used to store the destination addresses. An address cannot be entered
manually. When storing a broadcast transmission in a program, up to 500 destination address can be stored.
USING A PROGRAM
1
In scanner mode, load the document.
If you are going to use Dual
Page Scan (
page 26
) and
card shot (
page 29
), place
the document on the
document glass.
2
Touch the [SPECIAL MODES] key and
then the [PROGRAM] key.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(
page 11
).
3
Touch the program key you wish to
execute. Make sure the key is highlighted
and then touch the [OK] key.
The program key you
touched is selected and
you return to the screen
of step 2.
The [PROGRAM] key is
highlighted.
4
Touch the [OK] key.
You will return to the
initial screen.
5
If needed, set the original size and other
settings, and then press the [START] key.
Transmission takes place according to the
program.
NOTES
A program differs from a timer transmission (
page 27
) in that it is not cleared from memory after transmission
takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however,
that programs do not allow you to establish a timer setting for transmission.
Internet-Fax reception operations cannot be stored in a program.
PROGRAM
SPECIAL MODES
TIMER
SPECIAL MODES
ADDRESS REVIEW
FILE
QUICK FILE
G.
RAM1
OK
NOTE
Select functions that cannot be stored in a program
before you press the [START] key in step 5. These
functions include specifying the original size (See
"MANUALLY SETTING THE SCANNING SIZE" on
page 20
.), two-sided scanning (See "SCANNING
AND TRANSMITTING A TWO-SIDED ORIGINAL
(when using B/W scanner module/DSPF)" on
page
19
.), and timer transmission. (See "TIMER
TRANSMISSION" on
page 27
.)
DUAL PAGE
SCAN
SPEAKER
RESEND
OK