Oki C 9650dn Installation Instructions

Page of 2

Download

Bookmark us

Transfer Belt

Installation Instructions

Caution! The fuser is very HOT after the

printer has been printing. For your

safety, let the printer cool down at

least 10 minutes before attempting

to replace the transfer belt.

To replace the belt unit:

1. Turn off the printer.

Note:

If the hard disk drive is installed in

your printer, press the SHUTDOWN/

RESTART button for several seconds

before turning the printer off.

2. Open the top cover.

Caution! The fuser is very HOT after the

printer has been printing. Be

careful not to touch it!

3. Remove the four image drums/toner cartridge

units and place them on a flat surface.

4. Cover them with dark paper or plastic to

protect them from light.

5. Lift the transfer belt latches to release them.

58396901

1 2 Next › »

Page 1
Transfer belt installation instructions caution! The fuser is very hot after the printer has been printing. For your safety, let the printer cool down at least 10 minutes before attempting to replace the transfer belt. To replace the belt unit: 1. Turn off the printer. Note: if the hard disk drive i...
Page 2
6. Grasp the blue handles and lift the transfer belt out. Dispose of it in accordance with local regulations. Warning! Do not incinerate the used transfer belt. It may explode and cause a fire hazard. 7. Unpack the new transfer belt, grasp the blue handles and lower the left side of the belt into th...