Oki C5100n Installation Instructions

© 2003 Oki Data Americas, Inc.

58358801

Install the Tray

1. Unpack the tray and remove the 

shipping materials.

2. Turn off the printer and unplug the 

power cord.

3. Remove the interface cable.

4. Note the location of the pins (

1), 

connector (

2) and tray opening (3).

5. Lower the printer onto the auxiliary 

tray, aligning the printer with the 

tray and lowering the holes/plug in 

the bottom of the printer onto the 

pins/connector on the tray.

6. Reattach the interface cable.

7. Plug in the power cord and turn on 

the printer.

8. Print out the Menu Map.

a. Press 

+

 one or more times until 

INFORMATION MENU

 appears 

on the display.

b. Press 

ENTER

 twice.

The MenuMap prints.

9. Look for TRAY2 in the 

information at the top of the first 

page of the MenuMap and under 

the MEDIA MENU listing. If it 

isn’t there, check to be sure that the 

connection between the printer and 

Tray 2 is secure, then reprint and 

recheck the MenuMap. 

10. Check the MEDIA MENU 

settings shown on the MenuMap 

and make any needed changes for

• TRAY2  PAPERSIZE

• TRAY2 MEDIATYPE

• TRAY2 MEDIAWEIGHT

to match the print media you will 

normally use in Tray 2. (If you need 

help with this, see “How to Make 

Changes in the Menus” in your 

on-line User’s Guide, or refer to 

“Changing Default Media Weight 

Settings” in your Handy Reference 

Guide.)

Load Paper

1. Pull out the tray.

2. Fan the paper

3. Position the paper guides in the 

tray.

4. Load paper (up to 530 sheets, 

20-lb. US Bond), keeping the stack 

below the full line (

1).

5. Push the tray back into the printer.

B

ACK

E

NTER

O L

N INE

C

ANCEL

M

ENU

C5100/C5300 2

nd

 Paper Tray

Oki 42158501 Second Paper Tray

Installation Instructions

(continued on back)