Oki C7300 Series Software Installation Manual - Usb
9
USB
Install Printer Software for Windows 98
Install the PostScript Driver
□ Check that the USB cable is plugged in.
□ Turn the printer on.
□ Windows Add New Hardware Wizard displays. Click
Next.
□ Select Search for the best driver... Click Next.
□ Insert CD1 into the CD-ROM drive.
□ Select CD-ROM drive, clear other choices. Click
Next.
□ The OKI USB device is detected. Click Next.
□ The File is copied. Click Finish.
□ The Add New Hardware Wizard appears. Click Next.
□ Select Search for the best driver... Click Next.
□ Select CD-ROM Drive. Select Specify Location.
Uncheck other selections.
□ Click Browse. Navigate toyour CD-ROM
drive\Drivers\Parallel\Win9xme\Ps. Click OK.
□ Click Next.
□ Click Next.
□ Follow the on-screen instructions to complete the
installation.
□ Click Finish.
Install the PCL Driver
If you want to also install the PCL driver, use the Add
Printer Wizard.
□ Insert CD1into your CD-ROM drive. Click Start ®
Settings
® Printers.
□ Double Click Add Printer.
□ The Add Printer Wizard displays. Click Next.
□ Select Local Printer. Click Next.
□ Click Have Disk.
□ Click Browse. Browse to your CD-ROM
drive\drivers\parallel\Win9xMe\pcl. Click OK.
□ Click OK.
□ Select your printer model. Click Next.
□ Select the OP1USB1 printer port. Click Next.
□ Follow the on-screen instructions.
□ Click Finish.
Install Printer Software Utilities
□ With the CD installed in your CD-ROM drive, click
Start
®Run®Browse. Browseto your CD-ROM
Drive and double-click Install. Click OK.
□ The Licence Agreement appears. Click I Accept.
Click Next.
□ The Menu Installer displays. Click the Productivity
Software button.
□ Install the utilities you want following the on-screen
instructions.
To access the utility programs from your desktop, click
Start
®Programs®OkiData.
Activating the Duplex Unit, Internal
Hard Drive and 0ptional Paper Trays
If your printer has a duplex unit or internal hard drive
(standard on Models C7100dxn, C7300dxn, C7500dxn,
C9300dxn and C9500dxn) or optional paper trays, you
must enter the driver and activate them.
See page 6 for instructions on how to do this.