Oki MC160 User Manual - page 140
Scanning With the Machine
6-14
The information registered for the speed dial destination appears for two
seconds.
3
Press the
E
NTER
key again.
If an FTP address or an SMB address was selected, the destination
address is specified.
4
If an e-mail address was selected, press the or key to select
FIN-
ISH
, and then press the
E
NTER
key.
"
To add an additional e-mail address, select
ADD
in step 4, and
then specify the destination. When sending the data to an FTP
address or SMB address, multiple addresses cannot be specified.
To check the specified e-mail address, select
CHECK
/
EDIT
in
step 4. To delete an address, select
CHECK
/
EDIT
in step 4, and
then continue with step 2 of “Deleting a Specified Destination
Address”.
Selecting a Group Dial Destination
A maximum of 20 group dial destinations can be registered on this machine.
(A maximum of 50 e-mail addresses can be registered with one group.) Fol-
low the procedure described below to specify e-mail addresses from the reg-
istered group dial destinations as the recipient of the scan data.
"
For details on registering e-mail addresses as group dial destinations,
refer to “Registering Group Dial Destinations” on page 6-24.
"
A group dial destination containing a telephone number cannot be
used in Scan mode.
1
With the main screen (Scan mode) or
Can Use AddressBook
dis-
played, press the
A
DDRESS
BOOK
key three times so that
GROUP DIAL
appears.
2
Use the keypad to type in the number (between 1 and 20) for the group
dial destination, and then press the
E
NTER
key.
The information registered for the group dial destination appears for two
seconds.
3
Press the
E
NTER
key again.
4
Press the or key to select
FINISH
, and then press the
E
NTER
key.
"
To add an additional e-mail address, select
ADD
in step 4, and
then specify the destination.
To check the specified e-mail address, select
CHECK
/
EDIT
in
step 4. To delete an address, select
CHECK
/
EDIT
in step 4, and
then continue with step 2 of “Deleting a Specified Destination
Address”.