Paccar MX-13 Operator's Manual - page 30
Operating Instructions
3
Compression Brake
With the compression brake switch
ON, the brake automatically creates its
braking effect when you remove your
foot from the accelerator pedal.
The brake switch is located on the
accessory dash panel. It controls
whether the brake is ON (ready to slow
the vehicle down) or OFF (no braking
action).
•
Do not use the engine
compression brake to slow
the vehicle down when you are
bobtailing or pulling an empty
trailer.
•
Make sure the brake is OFF before
starting the engine.
•
After the engine is started, warmed
up, and you are ready to get under
way, turn the engine compression
brake switch ON for added braking
effect.
3-8
NOTE
If your vehicle is equipped with the
Eaton Vorad® system, operation of
the compression brake may be au-
tomatically activated.
Compression Brake Controls
Two (2) switches on the dash panel
control the engine compression brake.
A master switch turns the system ON
or OFF. A second switch, located
next to the master switch, controls
the braking effect. This switch allows
you to choose progressively stronger
braking to slow the vehicle down.
Engine compression brake controls
include:
•
On/Off switch.
•
3-position selector switch.
•
Clutch switch.
•
Throttle sensor.
•
Service brake pressure switch.
•
Eaton Vorad® Anti-Lock Braking
System