Paccar MX-13 Operator's Manual - page 69
Maintenance Procedures
After Replacing Oil Filter(s)
1. Reconnect the chassis battery
cable at the negative battery
terminal. See Warnings at
Centrifugal oil filter removal
preparation.
2. Add approved engine oil SAE
10W30 API CJ-4 to the maximum
level marked on the dipstick.
3. Start and run the engine for five
to ten minutes and check for any
oil leaks.
4. Remove oil collection pan and
dispose of any spillage properly.
5. Check engine oil level and top up
as necessary.
°
chassis must be on level
surface
°
wait at least five minutes if the
engine has been hot
°
pull the dipstick and wipe with
a clean, lint free cloth
°
reinsert the dipstick, then
remove and check the oil level
°
add approved engine oil
SAE 10W30 API CJ-4 to the
maximum level marked on the
dipstick
Replacing Fuel Filter
WARNING!
When removing the fuel filter, a
quantity of fuel will escape. Do not
smoke or allow an open flame in
close proximity. Failure to do so
could ignite a fire or cause an ex-
plosion which could result in serious
injury to you and/or bystanders. Fail-
ure to comply may result in death,
personal injury, equipment or prop-
erty damage.
NOTE
The fuel filter and the hand pump are
located on the left-hand side of the
engine.
5
5-29