Pacific Energy Fusion Installation And Operating Instructions Manual - Propane Conversion
22
070905-28
FSGA 5056.4221
Propane Conversion
1) Ensure that the burner, pilot and gas
supply are turned off and the appliance is
cool.
2) Remove door skin by holding the base
of the door and pulling up and outwards
(Fig. # 24).
3) Remove window and frame by unlatch-
ing the two latches, one each side of the
frame, using the handle provided
(Fig. # 25).
4) Note log positions. Carefully remove
them and set aside in a safe place for
reuse after the conversion is complete.
5) Remove two screws securing the
burner to the base of the firebox
(Fig. # 26). Slide the burner to the left
hand side to disengage from the orifice.
6) Remove air shutter from burner by
removing the securing screw, and discard
air shutter but replace screw (Figs. #27
and #28).
7) Remove orifice (marked 41) from
manifold using a 1/2 inch wrench.
Replace with orifice (marked 54) supplied
with this kit. Please apply a small amount
of pipe joint compound to the threads to
ensure a good seal (Fig. #29).
8) Reposition the burner over the orifice
and secure with the two screws
previously removed.
Note: Factory supplied components must be used to ensure correct
input. After conversion confirm proper manifold pressure.
Fig. #24
Fig. #25
Fig. #26
Fig. #27
Fig. #28
Fig. #29