Packet8 6755i User Manual - Line
64 — Model 6755i Series IP Phone User Guide
Line
Keys
, Programm
ab
le
Keys,
and Softkeys
Click on Operation->Expansion Module
2. For softkeys, select from "Key 1" through "Key 20" or for programmable keys,
select from "Key 1" through "Key 6".
3. In the Type field, select Intercom.
4. In the Label field, enter a label to apply to this key.
5. If configuring a softkey on the Bottom Keys, in the state fields, check (enable)
or uncheck (disable) the states you want to apply to this softkey.
6. Click
to save your changes.
None Key
You can set a softkey or programmable key to force a blank entry on the IP phone
display for a specific key. You do this by setting the key to none. The keys are
added in order (from key 1 to key 20) after any hard-coded keys have been
added. If a particular key is not defined, it is ignored. For more information about
key behavior, see "Key Display Behavior" on page 48.
Setting a None Key
Use the following procedure to configure a None key on the 6755i IP Phone. The
procedure shows the softkey screen as an example.
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Programmable Keys.
or
Packet8 Web Phone UI