PACOM SmartIP-16PD User Manual - page 64

Part 3 - Configuration

64

WAN

Designate the IP address type as Manual or DHCP.

Manual

t Set Type to Manual.

Manual lets you configure related settings manually. 

Configure IP Address, Gateway, and Subnet Mask 

settings manually using the remote control's arrow 

buttons or the virtual keyboard.

t DNS Server: Enter the DNS server's IP address. The 

IP address can also be entered using the virtual 

keyboard.

t Remote Port: The port used by the remote program 

to connect to the NVR. Choose a value between 1024 

and 65535. The port number can also be entered 

using the virtual keyboard.

t Remote Callback: Set the port number using for 

remote callback. The port number can also be entered 

using the virtual keyboard.

t Ping Test: Select to test the current WAN settings you 

made. 

1 

Enter the IP address of the NVR.

2 

Adjust the frequency of the ping test.

3 

Select Run to do the test. The test result is displayed.

4 

Select Close to exit.

t If using a firewall, select Change Port to change the 

port number to one that is permitted by the firewall.

t Changing the port temporarily severs the NVR's 

remote connection.

Remote point IP and port settings on the remote 

program must also be changed in order for it to 

connect to the NVR. 

t To use the UPnP (Universal Plug and Play) feature, 

select Use UPnP. If using an IP router (or NAT), UPnP 

service allows the device to automatically forward the 

port to the NVR.

t This port is used to access a port that has a private 

IP address.

t In order to use the UPnP service, the IP router (or 

NAT) must support UPnP port forwarding and have 

the relevant options enabled.

t Port number cannot be changed with Use UPnP 

selected.

t Status: Indicates the number of the port forwarded 

by the IP router (or NAT) to the NVR via UPnP service.