PACOM SmartIP-16PD User Manual - Overlapped Recording Search
Part 4 - Search
80
t If designating From or To settings manually, you will
be able to enable/disable the Check Time Overlap
option.
If the system's clock has been changed and the
designated From or To point exists at more than one
location, you will have to choose one. Only the events
that took place between the selected From and To
points will be searched. If Check Time Overlap has
not been selected, events from the entire From and To
range will be searched.
t Use event filters to include/exclude specific system
events such as Panic Record, Check Recording,
Check Alarm-In, Disk Almost Full, Disk Bad, Disk
Temperature, Disk S.M.A.R.T., Fan Error, eSATA
Disconnected and Disk Config Change from the
search.
Camera Filter
t Alarm-In: Select which channels to search alarm-in
events in.
t Motion: Select which channels to search motion
detection events in.
t Video Loss: Select which channels to search video
loss events in.
t Audio Detection: Select which channels to search
audio detection events in.
t Trip Zone: Select which channels to search trip zone
events in.
t Tampering: Select which channels to search
tampering events in.
t Text-In: Select which channels to search text-in
events in.
t Record Channel: Select which record channels to
search events in.
Selected record channels are searched for events with
at least one linked recording. If no camera is selected,
only the events with no linked recording camera are
searched.
Overlapped Recording Search
If the system's clock is changed to a point in the past,
overlapping recordings may be produced. Overlapped
recordings have to be searched in segments.
For example, making a recording from 1 o'clock to 5
o'clock, changing the system's clock at 5 o'clock to 3
o'clock, and then continuing to record until 6 o'clock
produces two recordings that overlap between 3 o'clock
and 5 o'clock. This results in two segments for the period
between 3 and 5.
1:00
2:00
3:00
4:00
5:00
3:00
4:00
5:00
6:00
Segment 1
Segment 2
When searching overlapped video recordings, you
can choose a specific point in time or a time frame. If
you use the Go to the Date/Time option and select a
point within the overlapped time period (4 o'clock, for
example), you must specify 4 o'clock in which of the
two existing segments.
If you use the Event Log Search or Motion Detection
option and select a time frame within the overlapped
time period (4 o'clock to 5 o'clock, for example), you
must choose between the two redundant sets of From
and To values. Selectable search ranges are as follows:
t 4 o'clock in segment 1 to 5 o'clock in segment 1
t 4 o'clock in segment 1 to 5 o'clock in segment 2
t 4 o'clock in segment 2 to 5 o'clock in segment 2