PACOM SmartIP-16PD User Manual - page 77

Part 4 - Search

77

Motion Search

Select Motion Search from the Search menu to bring 

up the Motion Search Setup window.

Motion Search cannot be performed while using a split 

screen layout. Select Single Screen mode.

Select Option... to configure Motion Search options.

t Select First under From and Last under To to search 

the recording from start to finish. Alternatively, you 

can uncheck the First and Last options and specify 

the search time frame manually.

t Type: Motion Search looks for motion in the selected 

area by comparing individual frames against their 

preceding frames. This means slow and gradual 

movements, no matter how long they persist, will not 

be recognized. In contrast, Museum Search looks 

for changes in the specified area by using the From 

frame as a reference. Museum Search, therefore, 

recognizes even minute deviations from the original 

From frame.

t The Zone setting can be configured in the identical 

manner as the Zone setting under System Setup - 

Motion Detection. For more information, refer to the 

Motion on page 56.

Museum Search may not function properly if the 

edge of the object is included in the Zone. For more 

accurate search results, set the inside of the object's 

edge as the detection zone.

t Sensitivity: Set to between 1 (Low) and 5 (High).

t Min. Blocks: The Min. Blocks option is available with 

Motion Search only.

Once all the options have been configured, select 

Search. Select search results entry to display the video 

recording on the left. To play the recording, exit the 

setup window by selecting Close.

Text-In Search

Select Text-In Search from the Search menu to bring up 

the Text-In Search window.

Select a Transaction to display the video recording 

that corresponds to the selected time and date (paused 

state).

Text-in information is superimposed on the screen at 

normal playback speed. The information is not shown 

under any other playback speed.