QMS Magicolor 2 Desklaser User Manual - page 166
Other manuals for Magicolor 2 Desklaser:
Supplementary Manual, Supplementary Manual, Install Manual, Supplementary Manual, Quick Setup Manual
Manual is about: Konica Minolta Magicolor 2 Desklaser: User Guide
of
276
6#$1.%
7%$
/ /
3
Open the printer’s front cover.
Squeeze the latch near the upper-right
corner of the cover.
Caution:
This is necessary, as it pulls
the toner cartridges forward slightly to
make room for the OPC belt cartridge.
You could damage the OPC belt if you
don’t do this.
»
Note:
The illustrations for steps 3
through 11 show the printer without the
duplexer. However, the instructions are
the same for both models.
4
Pull the latch to release the top
cover, and then open the top cover.
Caution:
If you have a duplex model,
make sure you have opened the
duplexer’s rear cover first. Forced
opening of the top cover first may
damage the unit.
5
Rotate up the two lock levers (one on
each side of the OPC belt cartridge)
to release the cartridge.