QOLSYS IQ PANEL Installation Manual - page 3
IQ DOOR/WINDOW- INSTALLATION MANUAL
QOLSYS CONFIDENTIAL AND PROPRIETARY PAGE 3 OF 6
© Last revised 2/27/15 All rights reserved
MOUNTING WITH PROVIDED ADHESIVE
•Remove the back of the sensor by pressing on the tab and
pulling the cover off
•Place the base of the sensor on the appropriate surface and
use 4 of the supplied screws to secure the mounJng plate to
the chosen locaJon
•To secure the magnet, remove the mounJng plate by
prying it off the magnet casing.
•Be sure the arrows on the top of the casing align with the
arrows on the sensor casing. The sensor and magnet should
not be mounted more than 0.4 inches apart.
•Use the 2 remaining screws provided to secure the magnet
mounJng plate in the proper locaJon. Clip the magnet
casing back into place once the plate is secure.
MOUNTING WITH PROVIDED HARDWARE
Push to remove
sensor cover
•Remove backing on one side of the large double-‐sided tape and sJck the
exposed side on the back of the sensor as shown.
•Remove the other side of the large double-‐sided tape and mount the
device according to the installaJon instrucJons
•Remove the backing one side of the small double-‐sided tape and place on
back of magnet
•Lineup the magnet with the sensor using the arrows shown on each device
respecJvely. Ensure the sensor and magnet are not separated more than
0.4 inches as shown.
•Remove the second side of the double-‐sided tape and secure the magnet.