QTech QSW-2800 series Configuration Manual - 1.2.1.3 Global Mode
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
10
Mode to modify all configurations of the switch. For this reason, a password must be set for
entering Admin mode to prevent unauthorized access and malicious modification to the switch.
1.2.1.3 Global Mode
Type the config command under Admin Mode will enter the Global Mode prompt
“Switch(config)#”. Use the exit command under other configuration modes such as Port Mode,
VLAN mode will return to Global Mode.
The user can perform global configuration settings under Global Mode, such as MAC Table,
Port Mirroring, VLAN creation, IGMP Snooping start and STP, etc. And the user can go further
to Port Mode for configuration of all the interfaces.
Interface Mode
Use the interface command under Global Mode can enter the interface mode specified. Switch
provides three interface type: 1. VLAN interface; 2. Ethernet port; 3. port-channel, accordingly
the three interface configuration modes.
Interface Type
Entry
Operates
Exit
VLAN Interface
Type interface vlan <Vlan-
id> command under Global
Mode.
Configure switch IPs,
etc
Use
the
exit
command
to
return to Global
Mode.
Ethernet Port
Type
interface
ethernet
command
under Global Mode.
Configure
supported
duplex mode, speed,
etc. of Ethernet Port.
Use
the
exit
command
to
return to Global
Mode.
port-channel
Type interface port-channel
command
under
Global
Mode.
Configure port-channel
related settings such
as
duplex
mode,
speed, etc.
Use
the
exit
command
to
return to Global
Mode.
VLAN Mode
Using the vlan
Mode. Under VLAN Mode the user can configure all member ports of the corresponding VLAN.
Run the exit command to exit the VLAN Mode to Global Mode.
DHCP Address Pool Mode
Type the ip dhcp pool
Pool Mode prompt “Switch(Config-
configured under DHCP Address Pool Mode. Run the exit command to exit the DHCP Address
Pool Mode to Global Mode.