QTech QSW-2800 series Configuration Manual - page 331
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
317
Global Mode
radius-server authentication host {
{
[access-mode {dot1x|telnet}]
no radius-server authentication host
Specifies the IP address and listening port
number, cipher key, whether be primary
server or not and access mode for the
RADIUS server; the no command deletes the
RADIUS authentication server.
radius-server accounting host {
address> | number>] [key <string>] [primary] no radius-server accounting host { address> | Specifies the IPv4/IPv6 address and the port number, whether be primary server for RADIUS accounting server; the no command deletes the RADIUS accounting server. 4. Configure the parameter of the RADIUS service Command Explanation Global Mode radius-server dead-time no radius-server dead-time To configure the interval that the RADIUS becomes available after it is down. The no form of this command will restore the default configuration. radius-server retransmit no radius-server retransmit To configure retry times for the RADIUS packets. The no form of this command restores the default configuration. radius-server timeout no radius-server timeout To configure the timeout value for the RADIUS server. The no form of this command will restore the default configuration. radius-server accounting-interim-update timeout no radius-server accounting-interim- update timeout To configure the update interval for accounting. The no form of this command will restore the default configuration. 5. Configure the IP address of the RADIUS NAS Command Explanation Global Mode radius nas-ipv4 no radius nas-ipv4 To configure the source IP address for the RADIUS packets for the switch. radius nas-ipv6 no radius nas-ipv6 To configure the source IPv6 address for the RADIUS packets for the switch.