QTech QSW-2800 series Configuration Manual - 2.1 Basic Configuration
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
15
Chapter 2 Basic Switch Configuration
2.1 Basic Configuration
Basic switch configuration includes commands for entering and exiting the admin mode,
commands for entering and exiting interface mode, for configuring and displaying the switch
clock, for displaying the version information of the switch system, etc.
Command
Explanation
Normal User Mode/ Admin Mode
enable [<1-15>]
disable
The User uses enable command to step into admin mode
from normal user mode or modify the privilege level of the
users. The disable command is for exiting admin mode.
Admin Mode
config [terminal]
Enter global mode from admin mode.
Various Modes
exit
Exit current mode and enter previous mode, such as using
this command in global mode to go back to admin mode, and
back to normal user mode from admin mode.
show privilege
Show privilege of the current users.
Except User Mode/ Admin Mode
end
Quit current mode and return to Admin mode when not at
User Mode/ Admin Mode.
Admin Mode
clock set
[YYYY.MM.DD]
Set system date and time.
show version
Display version information of the switch.
set default
Restore to the factory default.
write
Save current configuration parameters to Flash Memory.
reload
Hot reset the switch.
show cpu usage
Show CPU usage rate.
show cpu utilization
Show current CPU utilization rate.
show memory usage
Show memory usage rate.
Global Mode
banner motd
no banner motd
Configure the information displayed when the login
authentication of a telnet or console user is successful.