QTech QSW-2800 series Configuration Manual - 44.3 Ssl Typical Example
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
323
1. Enable/disable SSL function
Command
Explanation
Global Mode
ip http secure-server
no ip http secure-server
Enable/disable SSL function.
2. Configure/delete port number by SSL used
Command
Explanation
Global Mode
ip http secure-port <port-number>
no ip http secure-port
Configure port number by SSL used, the
“no ip
http secure-port
”command deletes the port
number.
3. Configure/delete secure cipher suite by SSL used
Command
Explanation
Global Mode
ip http secure-ciphersuite {des-cbc3-
sha|rc4-128-sha| des-cbc-sha}
no ip http secure-ciphersuite
Configure/delete secure cipher suite by SSL
used.
4. Maintenance and diagnose for the SSL function
Command
Explanation
Admin Mode or Configuration Mode
show ip http secure-server status
Show the configured SSL information.
debug ssl
no debug ssl
Open/close the DEBUG for SSL function.
44.3 SSL Typical Example
When the Web function is enabled on the switch, SSL can be configured for users to access
the web interface on the switch. If the SSL has been configured, communication between the
client and the switch will be encrypted through SSL for safety.
Firstly, SSL should be enabled on the switch. When the client tries to access the switch
through https method, a SSL session will be set up between the switch and the client. When
the SSL session has been set up, all the data transmission in the application layer will be
encrypted.