QTech QSW-2800 series Configuration Manual - page 402
of
415
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
388
57.4 NTP Function Troubleshooting
In configuration procedures, if there is error occurred, the system can give out the debug
information.
The NTP function disables by default, the show command can be used to display current
configuration. If the configuration is right please use debug every relative debugging command
and display specific information in procedure, and the function is configured right or not, you
can also use show command to display the NTP running information, any questions please
send the recorded message to the technical service center.