Quantum ATL M1500 User Manual - page 14
Quantum ATL M1500 User’s Guide Addendum - FC310 Router Option
Document 6421018-02, Ver. 2, Rel. 0
September 2002
14
FC310 Services Software Commands
Command Syntax
0
The following is a list of syntax used to describe command lines:
• [ ] indicates required entry
• indicates optional entry
• | indicates choose one entry
List of Abbreviations
0
The following is a list of abbreviations used to describe command
lines:
• fpFibre Channel port number (0 - 2)
• flFibre Channel LUN (0 - 31)
• sbSCSI bus number (0 - 3)
• stSCSI target ID (1 - 15)
• sl SCSI LUN (0 - 7)
Command Listing
0
A list of the currently available FC310 Services Software commands is
shown in
Table 3 Most Common
FC310 Services
Commands
Command
Description
Default
Syntax
FcConnMode
Set the connection mode for the
FC310 to arbitrated loop or point-
to-point. Applies to all three Fibre
Channel ports on each board.
loop
set fcconnmode [loop | ptp]
get fcconnmode
FcFairArb
Turn on or off the FC-AL
arbitration fairness. Applies to all
three Fibre Channel ports on each
board.
enabled
set fcfairarb [enabled |
disabled]
get fcfairarb
FcFrameLength
Specify the maximum number of
payload bytes in a Fibre Channel
frame. If the frame length is not
specified, the current frame length
is displayed.
2048
bytes
set fcframelength [512 | 1024 |
2048]
get fcframelength