Quantum ATL M1500 User Manual - page 15
Quantum ATL M1500 User’s Guide Addendum - FC310 Router Option
Document 6421018-02, Ver. 2, Rel. 0
September 2002
FC310 Services Software Commands
15
FcHard
Enable or disable Fibre Channel
hard address assignment. Under
soft addressing the FC310 loop
address is assigned during loop
initialization.
hard
set fchard [enabled | disabled]
get fchard
FcHardAddress
Set the value used as the FC-AL
hard address.
port 0 = 3 set fchardaddress [fp
[address]]
get fchardaddress [fp]
FcSCSIBusyStatus
Specify the SCSI status value
returned when the FC310 is unable
to accept a SCSI command due to a
temporary lack of internal
resources.
BUSY
set fcscsibusystatus [busy |
qfull]
get fcscsibusystatus
FibreBridgeName
Specify the 8-character name
assigned to the FC310 router.
set fibrebridgename [name]
get fibrebridgename
FibreBridgeTargetLUN
Specify the soft target LUN used
by the FC310 when addressed by
the host. This LUN is taken from
NVRAM.
set fibrebridgetargetlun [0 - 31]
RouteChange (Immediate)
Map a Fibre Channel port and
LUN to a SCSI bus, target, and
LUN. Valid route change entries
are:
fp (0-2)
fl (0-31)
sb (0-3)
st (0-15)
sl (0-7).
routechange [fp] [fl] [sb] [st]
[sl]
RouteOnline
Set the status of a route to online.
set routeonline [fp] [fl]
get routeonline [fp] [fl]
RouteOffline
Set the status of a route to offline.
set routeoffline [fp] [fl]
get routeoffline [fp] [fl]
RouteDisplay
List the currently mapped Fibre
Channel-to-SCSI routes.
routedisplay
routedisplay [fp]
routedisplay [online | offline]
routedisplay [fp [fl] ]
routedisplay [fp [online |
offline] ]
Command
Description
Default
Syntax