Quantum ATL M1500 User Manual - page 17
Quantum ATL M1500 User’s Guide Addendum - FC310 Router Option
Document 6421018-02, Ver. 2, Rel. 0
September 2002
FC310 Services Software Commands
17
SerialPortHandshake
Set the data handshaking method
used for controlling the flow
between the transmitter and
receiver (hardware, software, or
none).
none
set serialporthandshake [hard
| xon | none]
get serialporthandshake
SerialPortEcho
Turn on or off the echoing of
keyboard input.
off
set serialportecho [enabled |
disabled]
FibreBridgeModel
Report the specific FC310 model
information.
get fibrebridgemodel
SerialNumber
Report the FC310 board serial
number.
get serialnumber
FirmwareRestart
(Immediate)
Reboot the FC310 firmware.
firmwarerestart
ScsiPortReset
(Immediate)
Reset the specified SCSI bus.
scsiportreset [sb]
Temperature
Report the unit temperature in
degrees C.
get temperature
Zmodem (Immediate)
Transfer a firmware image or
NVRAM parameter file to or from
the router using ZMODEM file
transfer protocol.
zmodem [send [filename] |
receive]
MaxEnclTempAlrm
Sets/displays the maximum
enclosure temperature alarm of
the unit in degrees C (5-40 degrees
C).
set maxencltempalrm [5 - 40]
get maxencltempalrm
MinEnclTempAlrm
Sets/displays the minimum
enclosure temperature alarm of
the unit in degrees C (5-40 degrees
C).
set minencltempalrm [5 - 40]
get minencltempalrm
IdentifyFibreBridge
Causes the “Fault” LED on the
FC310 board to blink continuously
until disabled.
set identifyfibrebridge
[enabled | disabled]
Get identifyfibrebridge
Command
Description
Default
Syntax