Quantum ATL M1500 User Manual - page 16
Quantum ATL M1500 User’s Guide Addendum - FC310 Router Option
Document 6421018-02, Ver. 2, Rel. 0
September 2002
16
FC310 Services Software Commands
FcPortList
(Immediate)
List the available Fibre Channel
ports and their current status.
fcportlist
ScsiInitID
Specify the SCSI initiator ID to be
used on the specified SCSI port.
set scsiinitid [sb [0-15] ]
get scsiinitid [sb]
ScsiPortResetOnStartup
Specify whether the SCSI port
should be reset on power-up.
Reset
each SCSI
bus on
startup
set scsiportresetonstartup [sb
[enabled | disabled] ]
get scsiportresetonstartup [sb]
ScsiPortSelTimeout
Show the time (msec) that the
router waits for a response from a
SCSI device on the selected port
after a selection request.
256 msec
set scsiportseltimeout [sb [256
| 128 | 64 | 32 | 16 | 8 | 4 | 2
| 1 ] ]
get scsiportseltimeout [sb]
ScsiPortSyncTransfer
Specify whether synchronous SCSI
transfers should be negotiated
with devices on the specified SCSI
port.
enabled
set scsiportsynctransfer [[sb]
[enabled | disabled] ]
get scsiportsynctransfer [sb]
ScsiPortTaggedQueuing
Specify whether tagged command
queuing is allowed on the SCSI
port.
enabled
set scsiporttaggedqueuing [sb
[enabled | disabled] ]
get scsiporttaggedqueuing [sb]
ScsiPortUltra2
Specify whether the selected port
supports Ultra2 (LVD) transfers.
set scsiportultra2 [sb [enabled
| disabled] ]
get scsiportultra2 [sb]
ScsiPortWideTransfer
Specify whether wide SCSI
transfers should be negotiated.
enabled
set scsiportwidetransfer [sb
[enabled | disabled] ]
ScsiTargets
List the SCSI devices that are on
the referenced SCSI bus.
get scsitargets [sb]
ScsiPortList (Immediate)
List the available SCSI ports and
their status.
scsiportlist
ScsiTermination
Set the internal termination of the
referenced SCSI port.
enabled
set scsitermination [sb
[enabled | disabled] ]
get scsitermination [sb]
SerialPortBaudRate
Set the baud rate for the FC310
serial port (2400, 9600, 19200,
38400, 57600, or 115200).
9600
set serialportbaudrate [rate]
get serialportbaudrate
SerialPortStopBits
Set the number of stop bits for the
FC310 serial port (1 or 2).
1
set serialportstopbits [1 | 2]
get serialportstopbits
Command
Description
Default
Syntax