Quantum ATL M1500 User Manual - page 18
Quantum ATL M1500 User’s Guide Addendum - FC310 Router Option
Document 6421018-02, Ver. 2, Rel. 0
September 2002
18
FC310 Services Software Commands
DispEvent
Set the switches which control the filtering performed when
displaying events. Switches have the following meanings and
settings:
(subsystem) switch: mask that controls which subsystem
events are displayed. The mask is a byte value with the
following bit patterns corresponding to the currently
supported subsystems:
0x01 FCP Processor /i960
Interaction
0x02 SCSI Processor/i960
Interaction
0x04 Ethernet (Future)
0x20 NVRAM & Flash
To display the events from several different subsystems, use a
mask value equal to the logical OR of the corresponding
subsystem values. To display events from all subsystems enter
the value 3Fh for the mask.
(event_level) switch: mask that controls what reporting level
events are displayed. The mask is a byte value with the
following bit patterns corresponding to the currently
supported reporting levels:
0x01 Info; general information
0x02 Warning; unexpected situation/condition
0x04 Critical; operation limited/curtailed
0x08 Failure; hard failure
0x10 Other; otherwise not categorized
0x20 Debug; tracking events
To display events from several different reporting levels, use a
mask value equal to the logical OR of the corresponding
reporting levels. To display events for all reporting levels enter
the value 3Fh for the mask.
(status) switch: has the following two values which correspond
to the status of the events to be displayed:
all All events, regardless of their status values are displayed.
ngood Only events with a status other than good are displayed.
3Fh
3Fh
all
set dispevent [subsystem]
[event_level] [status]
get dispevent
Command
Description
Default
Syntax