Raleigh Pedelec Groove 2.0 User Manual - 4   Quick  Start

10  

Original User Manual | Pedelec Impulse 2.0 Ergo

4   Quick  start 

1.  Charge the battery completely before riding for the 

first time. Charge temperature: 0°C to 45°C. 

Charging the battery

SEAT TUBE BATTERY

2.  Remove the cover from the charging socket.

3.  Connect the plug of the charger to the battery.

Charging the battery

DOWN TUB

E B

ATTERY

SEAT TUB

E BATTERY

4.  Plug the charger in at the wall socket.

›

You must charge the battery completely before 

using it for the first time. Depending on the 

manufacturer of the cells, the batteries will have 

a charge state of between 30 and 50%.

›

You can also remove the battery from your 

Pedelec and charge it elsewhere. For more 

information, refer to 

➠

 Chapter 5 “Battery”

.

5.  Once all of the battery LEDs have gone out, the battery 

is fully charged. Pull the plug of the charger out of the 

charging socket and unplug the charger at the wall 

socket.

6.  a) 

Down tube battery: If you removed the battery for 

charging, replace it in the holder from the front/above. 

At the same time, the key must be in the lock and must 

be turned anticlockwise. Press the battery down into 

the holder until the locking mechanism engages.

6.  b) 

Seat tube battery: If you removed the battery for 

charging, reinsert the battery into the holder on the 

Pedelec from the left-hand side. Tilt the battery out-

wards at an angle of roughly 45° as you do so. Swivel 

the battery into the upright position until the locking 

mechanism engages. Now turn the key clockwise and 

remove it. The battery is now locked in place.

Installing the battery

DOWN TUBE BATT

ERY

SEAT TUBE BATTE

RY

7.  Now turn the key clockwise and remove it. The battery 

is now locked in place.

Locking the battery

DOWN TUBE BATTE

RY

SEAT 

TUBE BATTERY

8.  Make sure that the battery is securely positioned and 

that the key is no longer in the lock.

9.  Press the   button on the control unit to switch on the 

drive system.

10. a) 

Pedelec without backpedal function: After the wel-

come screen, the display shows the power-assist mode 

that was last set. Press the  /  buttons to select 

the level of assistance: 

ECO

 (low), 

SPORT

 (medium), 

POWER

 (high), 

ERGO

 (heart-rate-controlled) or no as-

sistance. Pressing once changes the level of assistance 

by one level. This works both ways, depending on 

which of the buttons you press.