Raleigh Pedelec Groove 2.0 User Manual - page 228

12  

Original User Manual | Xion Pedelec

5.1.3   Installing the battery 

1.  a) 

Down tube battery: Insert the battery into the bat-

tery holder of the Pedelec from the front/above. At the 

same time, the key must be in the lock and must be 

turned anticlockwise. 

 b) 

Seat tube battery: Insert the battery into the 

holder of the Pedelec from the left by tilting it out-

wards at roughly 45°. 

2.  Press the battery down into the holder until the lock-

ing mechanism engages. Now turn the key clockwise 

and remove it. The battery is now locked in place. 

3.  Make sure the battery is firmly in place.

Installing the battery

Installing the battery

Locking the battery

5.2  Battery information system

There is a display panel on the outer face of the battery 

which includes five LEDs and a battery key. The LEDs light 

up as soon as you press the battery key. Information about 

the charge state and capacity of the battery is provided 

based on the number of LEDs that light up and the way in 

which they light up. 

Down tube battery: battery charge state

5.2.1  Checking the charge state

Press the battery key briefly, the LEDs light up and display 

the current battery charge state.

DISPLAY

BATTERY CHARGE STATE

•••••

5 LEDs light up 

100-80%

••••

4 LEDs light up

80-60%

•••

3 LEDs light up

60-40%

••

2 LEDs light up

40-20%

•

1 LED lights up

20-10%

¡

1 LED flashes

10-0%

5.2.2  Checking the capacity

If you hold down the battery key for roughly five seconds, 

the LEDs show the current battery capacity. If the LED in 

the largest panel lights up, then the battery has a capacity 

of over 60%. If the capacity is below 60%, this is indi-

cated via the smallest LED. Only one of the two LEDs can 

light up at any one time.