Raleigh Pedelec Groove 2.0 User Manual - page 143
Original User Manual | Pedelec Impulse 2.0 Ergo
15
5.1.1 Removing the battery
1. Grip the battery by the handle, insert the key into
the lock and turn it anticlockwise. The battery is now
unlocked.
Unlocking the battery
DOWN TUBE BATTE
RY
SEAT
TUBE BATTERY
2. a)
Down tube battery: Grip the battery with both hands
and lift it forwards/upwards out of its holder. Hold the
battery tight to avoid dropping it. Place the battery
down on a suitable surface, which should be dry, flat
and non-flammable.
2. b)
Seat tube battery: Grip the battery by the handle
and remove it from the Pedelec by tilting it sideways.
Hold the battery tight to prevent it from falling out.
Removing the battery
DOWN TUBE BATT
ERY
SEAT TUBE BATTE
RY
3. You should now remove the key and keep it in a safe
place to prevent it from breaking off or being lost.
5.1.2 Charging the battery
Before charging the battery, read the information on
the charger carefully.
1. a)
Down tube battery: Take the charger provided
out of its packaging and plug it in at the wall socket
(230–240 V).
1. b)
Seat tube battery: Take the charger provided and
the docking station out of their packaging and plug
the mains plug into a socket (230–240 V). Connect the
charger to the docking station. The LED in the charger
now lights up briefly in red and then permanently in
green.
›
To charge the battery safely, the charger must be
placed on a suitable surface, which should be dry
and non-flammable.
›
Seat tube battery: The charger must stand on its
four feet. This is essential to ensure that the hot
air from the ventilation slots can dissipate.
2. a)
Down tube battery: Connect the plug of the charger
to the battery.
2. b)
Seat tube battery: Put the battery in the holder of
the docking station. The LED in the charger lights up in
green.
Charging the battery
SEAT TUBE BATTERY
3. a)
Down tube battery: Charging begins. If your charger
has an LED, this lights up red. The battery is charged in
five stages. When charging of one stage is in progress,
the corresponding LED flashes. If this stage has been
fully charged, the LED will light up permanently. Now
the next LED will begin to flash. After all five LEDs have
gone out, the battery is fully charged.
3. b)
Seat tube battery: Charging begins. The LED of the
charger lights up in green. The battery LEDs light up
one by one to indicate the progress of charging. The
battery is charged in five stages. When charging of one
stage is in progress, the corresponding LED flashes.
If this stage has been fully charged, the LED will light
up permanently. Now the next LED will begin to flash.
After all five LEDs have gone out, the battery is fully
charged.