Raleigh Pedelec Groove 2.0 User Manual - page 152

24  

Original User Manual | Pedelec Impulse 2.0 Ergo

Climb Assist: Choose from the following values using the 

/  button:

1

2

3

4

5

6

7

Confirm your selection using the   button.

You can influence the response time of the power sen-

sor with the Climb Assist. The lower the value you set, 

the less responsive the system becomes. The higher 

the value you set, the more dynamic the system be-

comes, but beware a yo-yo effect.

7.3.4.3  Miscellaneous

Choose from the following using the  /  button:

•

Factory settings

•

Software

•

Back

Confirm your selection by tapping the   button.

Factory settings: The following question appears: “Restore 

factory settings?”. Select “Yes” if you wish to reset the 

system to its original settings. Select “No” if you wish to 

retain all the settings you have made. Confirm your selec-

tion by tapping the   button.

Software: This takes you to the items:

•

Version

•

Update

•

Back

Make a selection using the  /  button, then confirm and 

go to that item by tapping the   button.

•

Version: Here the current software version of the 

motor is displayed.

•

Update: Here you can bring the software up to 

date. Your specialist cycle shop will perform a 

software update.

Select a language using the  /  buttons. Tapping the 

 button confirms your selection and takes you back to 

the menu sub-item display.

 Unit:  Under the item “Unit”, you can choose whether the 

distance travelled and speed are displayed in kilometres 

(km) or miles (mi). Use the  /  buttons to choose be-

tween kilometres (km) or miles (mph). Tapping the   but-

ton confirms your selection and then takes you back to the 

menu sub-item display.

7.3.4.2  Drive

Choose from the following using the  /  button:

•

Wheel circumference

•

Shift Sensor

•

Climb Assist

•

Back

Confirm your selection by tapping the   button. This 

takes you back to the menu sub-item display.

 Wheel circumference: You can set the “wheel circumfer-

ence” to any value between 

1540 mm and 2330 mm by 

pressing the  /  buttons on the control unit. Tapping the 

 button confirms your selection and then takes you back 

to the menu sub-item display.

A change to the setting becomes necessary, for ex-

ample, when you have the tyres on your Pedelec 

exchanged for some of a different size. In order to 

display the correct data, the new wheel circumference 

must be entered.

Shift Sensor: Choose from the following values using the 

/  button:

OFF

50 ms 100 ms 150 ms 200 ms 250 ms 300 ms

Confirm your selection by tapping the   button.

The Shift Sensor recognises gear shifting and imper-

ceptibly interrupts the power assist for fractions of a 

second. This enables you to move more smoothly and 

considerably faster through the gears. The higher the 

value you set, the longer the assistance is interrupted 

for, and the more time there is for shifting gears.