SAB Goblin 700 Manual - page 17

ASSEMBLY OF THE BALL ON THE HORN.

The rods going from the servos to the swash plate must be as 

vertical as possible. Not all servos are equal, so to better align 

them you can choose to use the supplied spacer H0031. 

Figure 4 illustrates this.

INSTALLATION OF SWASHPLATE SERVOS

The linkage ball must be positioned between 17-19 mm out on the servo arm (figure 1), recommended servo arm SAB

p/n [HA050/HA051]. The 120° placement of the servos inside Goblin means the arms are difficult to access. For this reason it is

advisable to ensure alignment of the servo arms (and sub trim set) before installation of the servos in the model (figure 2).

Proceed with installation following the instructions below. Figure 3 shows a completed installation.

Uniball M2 5H6

(H0064-S)

Socket Head Cap Screw M2x8mm

(HC008-S)

or

Socket Head Cap Screw M2x6mm

(HC004-S) without Uniball Spacer

Servo 2

SERVO ASSEMBLY 1, 2, 3

Servo 1

Uniball Spacer

[H0031]

(H0064-S)

Socket Head Cap 

Screw M2.5x12mm

(HC026-S)

Socket Head Cap Screw  

M3x6mm

(HC044-S)

Socket Head Cap 

Screw M2.5x8mm

(HC020-S)

Servo 1

Servo 3

Servo Spacer 

(H0075-S)

Servo 2

Servo 3

17-19mm

Servo 1

BAG 9

Page 15

Chapter 8, Installation Of Swashplate Servos