SAB Goblin 700 Manual - page 30

A

B

Battery Plate

(H0149-S)

Cylinder M2.5

(H0151-S)

Flat Head Cap 

Screw M2.5x5mm

(HC128-S)

BATTERIES

The battery tray system in the Goblin 700 is simple, but very effective.

The battery should be attached to the tray (Part H0149) with heat shrink, tape or velcro.

You can optionally use the battery protection tray (Part H0151) see Fig. 1, 2.

Before permanently mounting the batteries onto the battery tray, check the ideal position 

for the best center of gravity.

Cut the heat shrink around the carbon fiber tray locking pins. Fig. 3.

Battery Pack:

Slide the tray until it locks into the CNC stopper. Fig. 4, 5.

Using the velcro straps, making sure that the two locking pins are stopped against the frame spacer 

(Part1#H0003 and #H0151) Fig.6, 7.

BAG 19

Note: Using sandpaper, sand 

the slot where you insert the 

battery strap. This helps 

increase the life of the strap.

Page 28

Chapter 14, Battery