SAB Goblin 700 Manual - page 23

Tail Blade Grip

(H0327BL-S)

Flanged Bearing 

8x 12x3.5mm

(HC418-S)

Tail Pitch Slider 02

(H0407-S)

Spacer 

8.1x 9.2x3.2mm

Tail Pitch Slider 03

(H0054-S)

Tail Pitch Slider Assembly

Tail Shaft

(H0419-S)

Thrust Bearing

5x  10x4mm

(HC435-S)

Socket Head Cap 

Screw M3x8mm

(HC050-S)

Note: Larger ID

Socket Head Cap

Screw M2x6mm

(HC004-S)

Spacer

2x 3x3mm

(H0076-S)

Socket Head Cap

Screw M2x6mm

(HC004-S)

Bearing

5x  10x4mm

(HC411-S)

Tail Pitch Slider 01

(H0409BL-S)

Tail Blade Grip Assembly  .....x3

Bushing

(H0435-S)

Bearing

5x 10x4mm

(HC411-S)

Tail Pitch Slider Link

(H0056-S)

Tail Blade Grip 

Assembly

Washer 5x 7x0.2mm

(HC449-S)

Spacer

7.5x 10x0.5mm

(H0349-S)

Tail Pitch Slider 

Assembly

Tail System Assembly

Washer 

Ø3xØ7x1mm

(HC181-S)

Set Screws 

M4x6mm

(HC153-S)

Tail Hub

(H0418-S)

NOTE: After the use of Loctite, 

            need to the check the 

            proper sliding off all command 

Please read this user manual carefully, it contains instructions for the correct assembly of the model.

Please refer to the website www.goblin-helicopter.com for updates and other important information. Thanks you

Note:

It is a normal for the tail to feel a bit tight after initial assembly.

After 2-5 flights allowing the system to become smooth.

eg: Microlube 

      GL261

[H0327-S]

[HC449-S]

[H0418-S]

The set screw 

should align 

with the hole in 

the tail shaft

BAG 10B, FOAM 3

Page 21

Chapter 12, Tail System