SAB Goblin 700 Manual - page 25

Block Nut

(H0358-S)

Flat Head Cap 

Screws M3x8mm

(HC134-S)

Linkage Tail 

Support

(H0045-S)

Set Screw 

M3x20mm

(HC150-S)

Yellow Carbon 

Tail Boom (H9045-S)

Locking Element 

Tail Assembly

Locking Element Tail Assembly  .... X 2

Boom Spacer

(H0082-S)

Note:

Metric Hex Nylon Nut M3

(HC206-S)

DETAIL A

DETAIL C

Tail Boom Assembly 

Locking Element Tail

(H0041-S)

Attaching H0082-S to the boom:

Pre-assemble the two boom spacers H0082-S with 

the M3x20 socket set screw.

Insert into the boom tube completely done up.

Center the holes, then unscrew until there is contact with the walls

Lock everything with the adhesive.

Assemble H0040-S in the boom:

Before assembling the two parts in the boom we suggest tightening the 

M2.5 screws into the two plastic parts to pre-thread them. In this way 

when you will assemble the tail servo it will be easier to tighten the screws 

into the plastic parts. Check the tail servo can fit, if necessary carefully sand 

the hole.

Assemble H0045-S in the boom:

Before mounting H0045 on the boom we 

suggest to first tighten the M2.5 screws into the 

holes to thread them. In this way when you 

assemble the part it will be easier to tighten the 

screws.

Socket Head Cap 

Screw M2.5x6mm

(HC018-S)

Tail Servo Lock

(H0040-S)

Double 

Sided Tape

A

B

C

DETAIL B

BAG 14

Page 23

Chapter 12, Tail