SAB Goblin 700 Manual - page 18
Plastic ball link
(H0066-S)
Plastic ball link
(H0402-S)
Plastic ball link
(H0402-S)
Approx 76 mm
Approx 40mm
Approx 66mm
Initial length for the rods from the servos to the swash plate.
Approx. 49 mm
Plastic ball link
(H0066-S)
Initial length for the rods from the swashplate to the blade grips.
Set Screw M2.5x18mm
(HC140-S)
Linkade Rod B
Aseembly
Head HPS Version Preliminary Setup
Adjust the linkage as shown. The linkage Rod A has thead right/left.
Turning, you can change the tracking without disconnecting the
plastic ball link.
If it is necessary to tighten
then horn screws,use the
included hexagonal wrench
(HA002)
The wire for the front servo must be positioned here
Linkade Rod A
Aseembly
Linkage Rod B Assembly ... x3
Linkage Rod A Assembly ... x2
Linkage Rod
M3x50mm
(H0417-S)
Tool HA002
Page 16
Chapter 8, Installation Of Swashplate Servos