SAB Goblin 700 Manual - page 21

DE-BURR THE SIDE FRAMES

We recommend de-burring the edges of the carbon parts in areas where electrical wires run.

ESC INSTALLATION 

The speed controller (ESC) is installed in the front of the helicopter. 

Figure 1 shows the mounting area. Figure 2 shows the installation of the Kosmik ESC from Kontronik. 

You can also use the heat sink (H0165-S) if you wish for improved cooling (Figure 3,4,5)

Figure 6:  Shows the wiring which connects the receiver and ESC (in this picture one frame has been removed). 

                  If the BEC used is combined with the ESC, it is recommended to use a dual wire connection.

Figure 7: The passage of the controller wires to the motor is highlighted. 

Figure 8: Shows the installation of a 2S battery for the flight control system. 

                 Alternatively, a BEC could be placed in the same area.

ESC Cables

2S Battery  or  BEC

Page 19

Chapter 10, Installation Of The ESC