Sabo 52-S A Operator's Manual - page 69
17
GB
Engine performance decreases
Air filter dirty.
Clean or replace air filter insert W .
Spark plug contaminated with soot.
Have it cleaned by an authorized dealer.
Pos: 15.3.4 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungst abellenel emente/M otor läuft unr egel mäßig @ 0\mod_1127909273145_1521.doc @ 1891
Engine runs irregularly
Air filter dirty.
Clean or replace air filter insert W .
Spark plug contaminated with soot.
Have it cleaned by an authorized dealer.
Have it checked by an authorized dealer.
Pos: 15.3.5 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungst abellenel emente/M äher fährt nicht @ 0\mod_1115376736218_1521.doc @ 1889
Mower will not move forward
Drive control bracket not pulled.
Pull drive switch bar G .
Have it checked by an authorized dealer.
Pos: 15.3.6 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungst abellenel emente/Star ke Ersc hütterungen ( Vibrier en) @ 0\mod_1115377318234_1521.doc @ 1900
Extreme vibration
Have it checked by an authorized dealer
Pos: 15.3.7 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungst abellenel emente/Schnitt unsauber, R asen wird g elb, Benzin MUST ER @ 17\mod_1331728299135_1521.doc @ 134627
Cut not clean,
lawn turns yellow
Cutting blade blunt.
Have it sharpened and balanced by an
authorised workshop
Q
.
Cutting height too low.
Set higher cutting height I .
Motor speed too low.
Work at max. speed.
Mowing speed too high.
Adapt mowing speed, switch motor drive off
if necessary.
Insufficient overlap between mowing
lanes.
If grass is long, the mowing lanes may need
to overlap further.
Lawn matted.
A perceptible improvement can be achieved
by using a scarifier.
Pos: 15.3.8 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungst abellenel emente/Auswurf verstopft, Benzi n, Seitenauswurf, mit Antrieb MUSTER @ 23\mod_1362058094144_1521.doc @ 170270
Ejector blocked
Motor speed too low.
Work at max. speed.
Cutting height too low with grass too
high.
Set higher cutting height I .
Mowing speed too fast.
Adapt mowing speed, switch motor drive off
if necessary.
Grass is damp.
Allow the lawn to dry.
Pos: 15.3.9 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungst abellenel emente/Gemulchte Gr as si eht schl echt aus Seitenauswurf MUSTER @ 5\mod_1183466802540_1521.doc @ 35937
Mulched grass appearance is
poor:
clumps, excessive clippings,
rough cut.
Blade blunt.
Have it sharpened and balanced by an
authorized dealer.
Mulching rule not followed (cut max.
1/3 of the grass height; the height of
the grass to be cut must be lower
than 10 cm)
Adjust to higher cutting height I .
Convert mower to side discharge R3 and
mow grass first with higher cutting setting.
Grass build-up under deck.
Adjust to higher cutting height I .
Driving speed too high.
Adapt driving speed, switch motor drive off
if necessary.
Insufficient overlapping of cuts when
mowing.
Tall grass conditions may dictate that more
overlapping of cuts is required
Grass not dry.
Adjust to higher cutting height I .
Let grass dry.
Pos: 15.4 /Innenteil/Stör ungsursachen und deren Besei tigung/Störungsursachen und deren Beseitigung T ext Benzi n @ 0\mod_1115378183390_1521.doc @ 1905
In case of faults and defects which have not been listed here, please contact the nearest authorized dealer.
Repairs which require specialized knowledge should only be performed by a qualified expert. Your authorized dealer will
naturally also be glad to help if you do not wish to perform the maintenance work described here yourself.
===== Ende der Stückliste =====