Safewatch QuickConnect Plus Programming Manual - page 10
- 10 -
Data Field Display
Function& Programming Options
[ ] = Programmed Table 1 Default Values
90
90
90
90
EVNT LOG OPTIONS
EVNT LOG OPTIONS
EVNT LOG OPTIONS
EVNT LOG OPTIONS
Event Logging
Note:
System messages are logged when
any non-zero selection is made.
[3]
0 = None; 1 = Alarm/Alarm Restore; 2 = Trouble/Trouble Restore; 4 = Bypass/Bypass
Restore; 8 = Open/Close.
Example:
To select “Alarm/Alarm Restore”, and “Open/Close”, enter 9 (1 + 8); To select
all, enter #15.
91
91
91
91
AAV/REM
AAV/REM
AAV/REM
AAV/REM PHN
PHN
PHN
PHN CTRL
CTRL
CTRL
CTRL
Alarm Audio Verification (AAV)/Remote Phone Control
[2]
0 = None
1 = AAV and remote phone control
2 = remote phone control only
4 = AAV only
Notes:
(1) In order to activate the Remote Phone Control feature and defeat an answering machine,
ensure that the correct ring detection count (“15”) has been programmed in field ✻95.
(2) Remote phone session will be terminated if a report must be sent.
(3) Alarm Audio Verification will only function when Contact ID® is selected. AAV cannot be
used for UL installations.
(4) If an alarm will be reported to primary and secondary phone numbers, AAV can only
function via the secondary number.
(5) If an alarm will be reported to a follow me phone number (10-12 in field ✻49) AAV cannot
be used.
(6) If AAV is selected and LRR/IP communications device is enabled, you must enter "0"
(primary dialer preferred channel) as the second entry in Field ✻77.
92
92
92
92
SWINGER SHUTDOWN
SWINGER SHUTDOWN
SWINGER SHUTDOWN
SWINGER SHUTDOWN
Swinger Shutdown
[1]
1 = shutdown after one alarm; 2 = shutdown after two alarms
Note:
The control validates the data entered in this field. If the selection is not valid the control will
emit a single long beep indicating that the selection has been rejected. The control replaces
the selection with the default value “1”, which is displayed on the keypad, and advances to
the next field.
DOWNLOAD INFORMATION (✻93–✻95)
93
93
93
93
FLEXBLE
FLEXBLE
FLEXBLE
FLEXBLE CALLBACK
CALLBACK
CALLBACK
CALLBACK
Flexible Callback
[0]
0 = No flexible callback; 1 = Last digit flexible;
2 = Last 2 digits flexible; 3 = Last 3 digits flexible
94
94
94
94
DOWNLOAD
DOWNLOAD
DOWNLOAD
DOWNLOAD PHONE
PHONE
PHONE
PHONE
#
Download Phone Number
Note:
In UL installations, downloading may only be performed if a technician is at the site.
Enter up to 20 digits, 0–9; #+11 for '✻'; #+12 for '#'; #+13 for a pause. Do not fill unused
spaces. If fewer than 20 digits entered, pressing ✻ advances to the next field. To clear
entries from field, press ✻94✻.
95
95
95
95
RING
RING
RING
RING DET
DET
DET
DET COUNT
COUNT
COUNT
COUNT
Ring Detection Count for Downloading/Remote Phone Control Mode
[15]
0 = Disable Station Initiated Download
1–14 = number of rings
(1–9, [#]+10 =10, [#] +11 =11, [#] +12 =12, [#] +13 =13, [#] +14 =14);
15 = answering machine defeat ([#] +15 =15)