Sagem MF9300 Operation Manual - Staple Sort

37

CONVENIENT COPY FUNCTIONS

3

STAPLE SORT

 (when the finisher (SG-FN3) is installed)

This function collates the copies, staples each set, and delivers the sets to the offset tray. The staple sort function 

can only be used when a finisher is installed.

ORIENTATION OF THE ORIGINAL AND STAPLING 

POSITIONS

If the orientation of the originals does not match that of the copy paper, the images will be rotated. The stapling 

position varies with the orientation of the original.

Using the RSPF

Insert the originals face up.

Using the document glass

Place each original face down.

When copying B4 or A3 (8-1/2" x 14" or 11" x 17") vertically oriented originals, the copies will be stapled at the 

position shown below.

Stapling position

Top left corner

Portrait orientation

Landscape orientation

Available paper sizes:

A4 and B5 (8-1/2" x 11")

Stapling capacity:

For each size, up to 30 sheets 

can be stapled.

Available paper sizes: A3, B4 

and A4R, (11" x 17", 8-1/2" x 

14", 8-1/2" x 13", 8-1/2" x 11" R)

Stapling capacity: 

For each size, up to 30 sheets 

can be stapled.

Stapling position

Stapling position

• When using letterhead paper in the staple sort, load the paper with the 

letterhead to the front or to the right as shown in the diagram.

• Different sized originals cannot be copied on the corresponding sizes of paper.

• The staple sort function cannot be used if disabled in the key operator programs. (See the "Key operator’s 

guide".)

• The offset function (p.35) cannot be used.

Stapling position

RSPF

Stapling position

Document glass

Note

SHARP

SHARP