Sagem MF9300 Operation Manual - page 40
38
CONVENIENT COPY FUNCTIONS
1
Place the original(s). (p.22, p.23)
2
Touch the [OUTPUT] key.
3
Touch the [STAPLE SORT] key.
When the [STAPLE
SORT] key is selected,
the offset tray is
automatically selected as
the output tray. The top
tray and centre tray
cannot be used.
4
Touch the [OK] key.
5
Select the number of copies and other
copy settings, and then press the
[START] key (
).
6
[When using the RSPF:]
Copying will start after all originals have been
scanned.
[When using the document glass:]
Replace the original with the next original and
press the [START] key (
). Repeat this step
until all originals have been scanned, and then
touch the [READ-END] key.
If the memory becomes full while scanning the
originals, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear.
To copy only the originals that have been scanned,
press the [START] key (
). To cancel the job, press
the [CLEAR ALL] key (
).
2-SIDED COPY
OUTPUT
OUTPUT
TOP TRAY
OFFSET
TRAY
STAPLE
SORT
SORT
GROUP
OK
CENTRE TRAY
OFFSET
The number of originals that can be scanned
into memory can be increased by increasing
the memory allocation in the key operator
programs, or by installing more memory. (See
the "Key operator’s guide".)
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
Note