Samcen SCS8000E Administrator's Manual - page 22
-
- 14 -
gatekeeper, other MTs who registered in the same gatekeeper or adjacent
gatekeeper can call your MCU through the alias or E.164 number.
2.1.1.2
WAN Network
Determining all equipments in your videoconferencing system are deployed in the
WAN, then click <Next> to complete the following configuration:
1）
Select the proxy sever type
O
If some MTs manufactured by other companies in your videoconference
system, we recommend you clicking <Enable H.460 proxy>. When using
H.460 proxy and your SCS8000E located in the DMZ, please select <Enable
DMZ>, then input the router's public network address.
Note: The SCS8000E located in the DMZ is only applicable to the single ISP (Internet
Service Provider) line, does not apply to multiple ISP lines.
O
If your videoconference system adopts Samcen earlier version (prior to
V1.3.1) MTs, we recommend you clicking <Enable private proxy of
Samcen>.
2）
Select the number of ISP lines;
3）
Configure the network information
O
Single ISP Line: Click <Next> and choose the using Adapter Name, then fill
the IP Address, Subnet Mask and Gateway.
O
Multiple ISP Lines: The different Proxy addresses should be configured for
your MTs adopt the different ISP lines for accessing to MCU. Select the
Network and matching Adapter, then fill in the Proxy IP, Subnet mask and
Gateway information for the ISP line, after that, click <Add> button.
4）
Setup the alias and E.164 ID of the MCU. If successfully registered to the
gatekeeper, other MTs who registered in the same gatekeeper or adjacent
gatekeeper can call your MCU through the alias and E.164 number.
Note: In the multiple ISP lines case, if some MTs manufactured by other companies need
to register to the H.460 proxy server we recommend you registering the first H.460 proxy
address which has been configured in the MCU.