Samcen SCS8000E Administrator's Manual - page 36
-
- 28 -
7.1.4 Conference Recording
Conference recording needs the support of the Live Conferencing Recorder.
Recording
1）
Click Settings in Boardroom, select Record;
2）
Select online recorder, click <start>;
3）
Enter the record-file name in the pop-up interface and select record mode;
O
Strobe Recording: Used to record video streams in key frame mode;
O
Record with Dual Video: If Record with Dual Video is selected, the two
channels of code streams of the picture will be recorded; otherwise, only one
channel of code stream will be recorded.
Recording interface can display the currently recorded time length in real time, in
units of seconds.
7.1.5 Switching Participating MT Video Source
Some of the participating MTs with two video source: Video Source 1 and Video
Source 2, Video Source 1 is usually a built-video source, Video Source 2 is an
external.
Switch Video Source in two easily methods
Method 1
Click Settings in Boardroom, select MT Video Source in the pop-up menu.
Way 1
1）
Select a solution in the list;
2）
Click Load.
Way 2
1）
Select an MT from the MT(s) Available list
；
2）
Choose a video source port from the Video Source Port drop-down list;
3）
Click
or , put the designated terminal into MT(s) Selected list.
Way 3
1）
Click
or
, put the designated terminal into MT(s) Selected list;
2）
Select the MT in MT(s) Selected list, right click, choosing a video source port.
The user can also save the video source settings as solution; load existing
solution; and delete unnecessary solution.
Method 2
Right click the MT in Boardroom interface, then select Video Source > Video
Source 1(Video Source 2).
If the selected video source does not access, the MT’s video screen prompts no
video source, select the video source connected normally.