Samsung AQ07P8GE Training Manual - page 97
96 | SAMSUNG
8
TROUBLESHOOTING
Set up the Model Option
(Cont.)
Step 3 : Reconfirming option set after completion
(in case of ex. 066025-172362)
After pressing
selector for the
mode, the display shown as
.
After pressing
selector for the
mode, the display shown as
.
Step 4 : Pressing the ON/OFF button (
)
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound “Ding” or “Diriring” is
heard and the OPERATION LED lamp is flickering at the same time, then the input of option is completed.
(If the diriring sound isn’t heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
!
If the first number is
, it is correct otherwise press
until
appear.
@
When pressing the
button
~
appear on the display, select
one of them.
#
When pressing the
button
~
appear on the display, select
one of them.
$
When pressing the
button
~
appear on the display, select
one of them.
%
When pressing the
button
~
appear on the display, select
one of them.
^
When pressing the
button
~
appear on the display, select
one of them.
Error Mode :
1
st
If all lamps of indoor unit are flickering, Plug out and plug in again and pressing ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see
if the correct option code is set up for it’s model.
DB98_08187A(1)_57~100 3/27/03 2:24 PM Page 96