Smartlink MEDI-CALL UNIT Installation Manual - page 18
Medi-Call V2.0 – V2.7 Installation Manual
17
Option Description
RINGS DETECTED (Default 2 = 2 Rings)
2 – 9 Rings to detect before automatically answering after an alarm event.
1. “rd” is displayed on the SmartLink unit.
2. Press the HELP Button to view programmed Number of Rings.
3. Pressing the HELP Button again to step through Number of Rings (2, 3, 4, 5, 6, 7, 8, or 9 Rings).
4. To store an option selected, press the CANCEL and HELP Buttons at the same time. The SmartLink unit
will beep twice while flashing the display to acknowledge that the option has been selected.
5. Press the CANCEL Button to move to the next Program Option.
COUNTRY -
(Note: V2.0 to V2.6 only – Default According to Country)
(Note: V2.7 onwards – Default to Country “c5”)
AUSTRALIA (or AU)
NEW ZEALAND (or NZ)
SINGAPORE, USA & CANADA
UK & EUROPE
To be advised (Refer SmartLink)
1. “Co” is displayed on the SmartLink unit.
2. Press the HELP to view programmed option.
3. Pressing the HELP Button again toggles between AU & NZ or c1, c2, c3, c4 & c5.
4. To store an option selected, press the CANCEL and HELP Buttons at the same time. The SmartLink unit
will beep twice while flashing the display to acknowledge that the option has been selected.
5. Press the CANCEL Button to move to the next Program Option.
UP/DOWNLOAD & Remote DTMF Control (Default 1 = Enabled)
(V2.0 to V2.2 only) Enabled only in Program Mode and DTMF Enabled
(V2.0 to V2.2 only) Enabled all the time and DTMF Enabled
(V2.3 onwards) Enabled only in Program Mode and DTMF Disabled
(V2.3 onwards) Enabled all the time and DTMF Enabled
(V2.3 onwards) Enabled only in Program Mode and DTMF Enabled
(V2.3 onwards) Enabled all the time and DTMF Disabled
1. “ud” is displayed on the SmartLink unit.
2. Press the HELP Button to view programmed option.
3. Pressing the HELP again toggles between 0 & 1 or 0, 1, 2 & 3.
4. To store an option selected, press the CANCEL and HELP Buttons at the same time. The SmartLink unit
will beep twice while flashing the display to acknowledge that the option has been selected.
5. Press the CANCEL Button to move to the next Program Option.
DEFAULT VALUES –
Sets all Preference Programming Options to Default Values
To Set all the Preference Programming Options to Default Values:
1. “dF” is displayed on the SmartLink unit.
2. Press the HELP Button. The SmartLink unit will beep twice while flashing the display “- ” to indicate
that ALL Preference Programming Options have been defaulted.
3. Press the CANCEL Button to move to the next Program Option.