Smartlink MEDI-CALL UNIT Installation Manual - page 23
Medi-Call V2.0 – V2.7 Installation Manual
22
5.2.9 DOOR BELL TUNE PROGRAMMING OPTIONS (V2.5 Onwards)
DOOR BELL 1 TEMPO (Default = 50)
0 – 255 (duration of a typical note in 10msec intervals).
Note: If set to 0 then Disabled Door Bell 1 Tune entirely.
1. “P1” is displayed on the SmartLink unit.
2. Press the HELP Button to view programmed tempo. The programmed tempo will flash on status display.
If you wish to view the programmed tempo again, press the CANCEL and then HELP. “ -” is displayed
and flashes on the SmartLink unit.
3. Pressing the HELP Button again to step through the digits (1,2,3,4,5,6,7,8,9 and 0). Press the CANCEL
and HELP Buttons at the same time to store each digit. The SmartLink unit will beep twice and display
the next digit to be programmed. Repeat this process until all digits are programmed.
4. Press CANCEL Button to display the programmed tempo. The SmartLink unit will flash on status display
for each digit and beep twice at the end of the programmed time stored.
5. Press the CANCEL Button to move to the next Program Option.
DOOR BELL 1 TUNE TONES (Default = 75629026759)
Programmed as the first digit will delete the tune. (Note: up to 50 Digits maximum)
//
0 = Pause 1 = C4 (Middle C) 2 = D4 3 = E4 4 = F4 5 = G4 6 = A5 7 = B5
8 = Halves the duration of the previous tune. 9 = Doubles the duration of the previous tune.
The tune is scaled up by an octave.
Sharp
1. “t1” is displayed on the SmartLink unit.
2. Press the HELP Button to view programmed tunes. The programmed tunes will flash on status display. If
you wish to view the programmed tempo again, press the CANCEL and then HELP Button. “ -” is
displayed and flashes on the SmartLink unit.
3. Pressing the HELP Button again to step through the digits (1,2,3,4,5,6,7,8,9.0, * and H). Press the
CANCEL and HELP Buttons at the same time to store each digit. The SmartLink unit will beep twice and
display the next digit to be programmed. Repeat this process until all digits are programmed.
4. Press CANCEL Button to display the programmed tunes. The SmartLink unit will flash on status display
for each digit and beep twice at the end of the programmed tunes stored.
5. Press the CANCEL Button to move to the next Program Option.
DOOR BELL 2 TEMPO (Default = 40)
DOOR BELL 2 TUNE TONES (Default = 39199039199)
DOOR BELL 3 TEMPO (Default = 40)
DOOR BELL 3 TUNE TONES (Default = 593919905939199)
DEFAULT VALUES –
Sets all Door Bell Tune Programming Options to Default Values.
1. “dF” is displayed on the SmartLink unit.
2. Press the HELP Button. The SmartLink unit will beep twice while flashing the display “- ” to indicate
that ALL Door Bell Tune Programming Options have been defaulted.
3. Press the CANCEL Button to move to the next Program Option.
5.2.10 EXIT PROGRAM MODE
EXIT PROGRAM MODE
1. “PE” is displayed on the SmartLink unit.
2. Press the HELP Button. The SmartLink unit will beep three times while flashing the display “ 0” for 3
seconds to indicate that SmartLink unit has Exited Program Mode and is ready for Operation.