Spypoint LINK-3G User Manual - page 7
7
The battery level is shown in the bottom right corner of the screen when
the camera is in TEST mode. When a single line remains,the camera will
continue to take photos. However, we strongly recommend to change the
AA batteries or charge the lithium battery pack before they are empty. If a
video is being recorded and the battery level reaches 0%, the camera saves
the file before shutting down.
aa BattERIES
This camera requires 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly
recommended.
To ensure maximum performance of the ca-
mera and prevent battery leak, we recom-
mend the use of new batteries. Make sure to insert
each battery with the correct polarity. (Negative or
flat end agaist the metal spring plate) Do not mix
battery type - use ALL alkaline or ALL lithium. Do
not mix old and new batteries. Rechargeable AA
batteries are not recommended as the lower voltage
they produce can cause operational issues.
lIthIUM BattERy PaCk
This SPYPOINT camera can be powered by a re-
chargeable lithium battery pack LIT-09/LIT-C-8
(sold separately). This type of battery is less
affected by cold temperatures and lasts up to 3
times longer than an alkaline batteries.
ExtERnal (12V)
This camera can also be powered by an external 12-volt DC input such as
a 12-volt battery (KIT-12V, BATT-12V or KIT6V/12V) or a 12-volt adapter
(AD-12V), sold separately.
SolaR PanEl
This camera also offers the possibility to connect a solar panel (SP-12V sold
separately) to maintain the charge of the lithium battery pack (sold sepa-
rately). While installing the rechargeable lithium battery pack, the LIT-09
CHARGER option located in the GENERAL SETTINGS menu should be "On"
to activate the charging system of the solar panel.
Power