SSHC TSSHC-3NPSBFS-16A User Manual - • Parts Supplied:
INS-TSSHC-3NPSBFS-16A-1209
4
Installation work and electrical wiring must be done
by qualified person(s) in accordance with all applica-
ble State/Country codes and standards.
• Parts supplied:
• one (1) thermostat;
• two (2) mounting screws;
• four (4) solderless connectors suitable for copper wires; and
• one (1) floor sensor.
2. Installation
Thermostat selection and sensor location
The preferred thermostat location is on an inside wall four feet
(1.2m) above the floor, in a conveniently accessed locations
such as next to the light switch, and away from random temper-
ature impacts detailed in the examples that follow.
Do not install the thermostat in a location where temperature
measurements could be altered. For example:
• close to a window, on an external wall, or close to a door
leading outside;
• exposed directly to the light or heat of the Sun, a lamp, a
fireplace or any other heat source;
• close or in front of an air outlet;
• close to concealed ducts or a chimney; and
• in a location with poor air flow (e.g. behind a door), or with
frequent air drafts (e.g. head of stairs).
To install the sensor, refer to the installation guide of your heat-
ing floor.
Thermostat mounting and connection
1.
Cut off power supply on lead wires at the electrical
panel in order to avoid any risk of electric shock.
2. Ensure that the air vents of the thermostat are clean and clear
of any obstruction.