TANDBERG 3000 MXP Profile User Manual - page 14
TANDBERG 3000 MXP Profile
14
Column and Base
The Roll About system is easily movable due to large wheels and handles, at the back of the
monitor. The codec is located inside the bracket assembly behind the monitor. Inside the column
assembly, there is room for additional equipment, e.g. a VCR or a DVD player.
Remote Control
The remote control is used to control all functions of the system. If the screen saver is activated
(black monitor), wake up the system by picking up the remote control. The remote control uses 4
AAA batteries. The system will tell you when batteries are running low. Change the batteries at
the back of the remote control.
The reach of the remote control signal is 20 meters (65 feet). For users sitting in an open plan
office, this can cause problems. Use the little, white switch placed under the batteries to change
the reach of the signal from 20 meters (65 feet) to 2 meters (6.5 feet). This will prevent you from
unintentionally controlling another video system, when you control your own system.
Microphone
The high quality table microphone is designed to be placed on a table during a videoconference.
Up to three microphones can be connected. The ideal location for the microphone is on a flat
surface at least 2m (6.5 ft) from the front of the system. The microphone cable should always
point towards the system. The system will automatically equalize sound levels. Loud and soft
voices are picked up and transmitted to the far end at approximately the same level.