TANDBERG 3000 MXP Profile User Manual - 3 General Use
Other manuals for 3000 MXP Profile:
Administrator's Manual, User Manual, User Manual, User Manual, User Manual, User Manual, Installation Manual
of
284
3 General Use
Wake up the system
When the system is not in use, it is in standby mode and the screen is black. Wake up the system
by picking up the remote control. An incoming call or pressing any key on the remote control will
also wake up the system.
If the system does not respond:
Make sure that the system is switched on by using the On/Off switch located at the rear
of the Codec.
Verify that your monitor is switched on. This is normally done by pushing the power
button on the front of the monitor depending on monitor type.