Thermador Professional P24WK Installation instructions manual - page 11
P
AGE
11
The stainless steel surfaces may be cleaned by wiping
with a damp soapy cloth. Any mild glass cleaner will
remove fingerprints and smears.
Follow all cleaning by rinsing with clear water. Wipe dry
with a clean soft cloth to avoid water marks. For
discolorations or deposits that persist, use a non-
scratching household cleanser or stainless steel polish-
ing powder with a little water and a soft cloth. For
stubborn cases, use a plastic scouring pad or soft bristle
brush together with cleanser and water. Rub lightly in
direction of polishing lines or “grain” of the stainless
finish. Avoid using too much pressure which may mar
the surface.
Use a stainless steel cleaner/polish to protect the finish
and maintain appearance.
DO NOT allow deposits to remain for long periods of
time.
DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface causing
rust.
DO NOT allow salt solutions, disinfectants, bleaches
or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these
compounds contain chemicals which could prove harm-
ful. Rinse with water after exposure and wipe dry with
a clean cloth.
LOW BACK AND ISLAND TRIM MODEL NUMBERS
COOKTOP MODEL NO.
12" LOW BACK
Island Trim*
P24WK
GP24LBS
GP24ITS
PSC36
GPS36LBS
GPS36ITS
PSC48
GPS48LBS
GPS48ITS
*Requires a minimum of 12" horizontal clearance between back of appliance and combustible materials.
TO CLEAN AND PROTECT EXTERIOR SURFACES
STEP 6: Backguard Installation
A Low Back backguard must be installed
when there is less than a 12" clearance
between combustibles and back edge of
cooktop. (See Fig. 1 and 5.) For island
installations and other installations with
over 12" clearance, an optional stainless
steel trim channel is available to cover the
backguard mounting flanges. Attach the
backguard before sliding the appliance into
the final installed position. Follow Steps A
through C below:
A. Slide backguard over the two flanges on
the rear of the appliance. Fasten the
front and back with two screws (see A,
Fig. 12) provided. No screws are re-
quired behind the griddle section.
B. Fasten the top of the backguard to the
wall with two screws through the
backguard. (See B, Fig. 12.)
C. Place the backguard cap on top and
fasten using the two counter-sink screws
provided. (See C, Fig. 12.)
Fig. 12 Low Back Attachment
C
B
A